Williams System 3-6 Power Supply - Electrolytic Capacitor kit

Electrolytic capacitor set for Williams System 3 through System 6 Power Supply Boards

Kit includes all new matching capacitors.

C7, C11:

Original = Axial Electrolytic 100uF, 150 Volt

Kit = Axial Electrolytic 100uF, 160 Volt

GPE part number CEA-100uF-160V-RMD

C13:

Original = Axial Electrolytic 100uF, 100 Volt

Kit = Axial Electrolytic 100uF, 100 Volt

GPE part number CEA-100uF-100V-RMD

C15:

Original = Axial Electrolytic 12000uF, 16 Volt

Kit = Axial Electrolytic 12000uF, 25 Volt

GPE part number CEA-12000uF-25V-RMD

Cable tie incuded for C15.

Notes:

Higher voltage rated capacitors are a good substitute for lower voltage rated devices.

Some boards were manufactured with a tantalum capacitor at C16, some were manufactured with a cheaper electrolytic capacitor at C16.

Tantalum capacitors do not age like electrolytic capacitors and can last indefinitely therefore they are not

included with the standard kit. Tantalum's should be used in this position - if replacing C16 then this capacitor can be added as an option.

Observe proper polarities when installing parts.

Improper installation can result in damage and/or injury.

All caps in this kit are polarized. Care must be taken to install all caps in the proper direction. Tantalum capacitor positive terminal is chamfered or marked with "+" marks.

For use in the following machines: System 3: Hot Tip, Lucky Seven, World Cup, Contact, Disco Fever

System 4: Phoenix, Pokerino, Flash, Stellar Wars

System 6: Tri-Zone, Time Warp, Laser Ball, Gorgar, Firepower, Blackout, Scorpion, Alien Poker, Algar