Details
Reference : 64718
Ref. Part No.: A-16922, A-18543-1, A-18543-2, A-19237
R1 = 0 Ohm for use in the Twilight Zone
R1 = 4.7 kOhm for use as a sensor board
Restistors included!
Installation:
Place the board in the location in the machine. Use a single screw to hold it in place while you test.
Connect the 4-pin (switch matrix) and 2-pin (sensor) connectors.
Turn the machine on.
Using a small screwdriver, turn the pot from end to end. It will rotate through about 3/4 of a turn.
At one end, the LED will go on. When that happens, slowly turn the pot the in the opposite direction until the LED goes off.
If the LED does not go off, your sensor or its wiring have a problem.
Place a ball on the top of the playfield in the sensor area. The LED should light when the ball rolls over the sensor.
To get an approximate freight quote in AU$ add your items to the shopping cart and click "Get a Quote"
Our Social Media pages
We are the largest pinball parts supplier in Australasia - Yes we ship worldwide! Paypal welcome here!
Pinball Machines Australia
Australian customers can see our PINBALL MACHINE sales site here - PinballMachinesAustralia.com.au
